Advertisement
ZeroWire Web Server
ZeroWire has a built in web server which makes it easy and simple to set up your system from a
web browser instead of the keypad.
Features
Simple forms to set up most commonly used features
View status of Partitions
View system conditions
Remotely arm and disarm partitions
Turn chime mode on and off
Bypass/Un‐bypass sensors
Add, remove and edit users
Add, remove and edit Z‐Wave devices
View Z‐Wave device status
Control Z‐Wave devices
Enter Installation menu and perform advanced programming for ZeroWire
Wireless Setup
To connect via local WiFi you will need a router supporting 802.11 b or 802.11g
1. Power on ‐ Connect power to your ZeroWire
2. Enable WiFi on ZeroWire ‐ On the ZeroWire press Menu – 9 – [PIN] – 8. This will enable
WiFi Discovery Mode for 10 min.
3. Enable WiFi on your device ‐ Turn on WiFi on your device (such as a smart phone, tablet
computer or laptop).
4. Connect to ZeroWire ‐ Browse for available WiFi networks and select the 'ZeroWire_xxx"
network to connect to it. Only a single user can connect at any time and there is no
password. Once connected the ZeroWire will be assigned a fixed IP address of 192.168.1.3
and a domain name of ZeroWire.
5. Open Web Browser ‐ Open your web browser and enter http://192.168.1.3 or ZeroWire.
The ZeroWire login screen should appear:
6. Login ‐ Enter your username and password, by default this is installer and 9713
‐ 40 ‐
Advertisement
