Advertisement
7. You should now see a screen similar to below:
Wired Setup
1. Connect power to your ZeroWire.
2. If this ZeroWire was previously connected via WiFi, switch connection mode to switch to
Ethernet by pressing Menu, 9, Master PIN, 7. Press 7 again if it announces "WiFi is on". The
ZeroWire will announce "Ethernet is on" when this is set correctly. Press Menu, Menu to
exit.
3. Connect an Ethernet cable to the rear of the ZeroWire and wait 10 sec for the local router
to assign the ZeroWire an IP address.
4. On the ZeroWire press Menu, 8, [Master PIN], 6 and note the IP address announced. If you
hear "IP address is not configured" then wait a further 30s and repeat this step.
5. Open your web browser.
6. Enter the IP address from step 3 and the ZeroWire login screen should appear. Some
browsers may require you to enter http:// before the IP address.
7. Enter your username and password, by default this is installer and 9713.
‐ 41 ‐
Advertisement
