Unit - Canon imagePRESS C7010VPS Operating Information Manual

Replacing the staple cartridge in the stapler unit
Replacing the staple cartridge in the stapler unit
Introduction
This section describes the procedure for replacing the staple cartridge in the optional
Finisher-AJ1 or Saddle Finisher-AJ2.
#
IMPORTANT
Take care when handling the optional equipment that is attached to the machine.
When an optional unit's cover is opened to replace a staple cartridge, discard punch
waste, or clear paper or staple jams, prints may still be output if other optional units
are operating normally, and are not involved in the paper or staple jam removal pro-
cedure.
#
NOTE
We recommend that you order staple cartridges from your local authorized dealer
before your stock runs out.
Replacing the staple cartridge in the stapler unit
Open the front cover of the finisher.
1.
Pull out the staple case from the stapler unit, holding it by its green tab.
2.
296 Chapter 9 - Paper, toner, and staples