Function - Canon imagePRESS C7010VPS Operating Information Manual

Activate the hotfolder function
Activate the hotfolder function
Introduction
The information in this section is intended for system administrators.
Note:
By factory default, the hotfolder function is disabled. To use the hotfolder function, the
system administrator must activate this function once. After the system administrator
activated the hotfolder function, up to 10 hotfolders can be defined.
How to activate the hotfolder function
Note:
For this procedure, the System administrator password is required.
Open the web browser and enter the host name or IP address of your PRISMAsync
1.
controller.
Go to the 'Workflow' -> 'Hotfolders' section.
2.
Click 'Configure'.
3.
At 'Enabled', select 'Yes' to activate the hotfolder function.
4.
Enter a unique 'Hotfolder user name' and 'Hotfolder password'.
5.
Make sure that you filled in the user name and password before you continue with the
next step.
Click 'OK' to confirm the activation of the hotfolder function.
6.
A confirmation window opens.
Click 'OK' to restart the controller now.
7.
Introduction to automated workflows, on page 319
Introduction to hotfolders, on page 325
Activate the hotfolder function, on page 326
Create a hotfolder, on page 327
Create a shared network folder on a workstation, on page 328
Create a hotfolder default ticket ('default_ticket.jdf'), on page 330
326 Chapter 10 - Adapt printer settings to your needs