Combine Jobs - Canon imagePRESS C7010VPS Operating Information Manual

Combine jobs

Introduction
The bundle function allows you to combine 2 or more jobs into 1 new job. For example.
this can be convenient when the participants of a meeting need several documents in a
specific order. Often, the required documents are sent from several workplaces to the
printer in advance. Normally, this means that you must print the documents first and
sort or staple them later. By using the bundle function you can determine the order of
the documents before printing and print all documents in the correct order in only 1
print job.
Important information about the bundle function
You can only bundle print jobs that are currently in the list of 'Waiting jobs'.
You can change a number of settings for the bundled job via the 'Properties' window.
By default, the number of sets for a bundled job is 1. So before printing, you must
first indicate the required number of sets (see...).
When you stop a job after a set, the printing stops after 1 copy of the complete bundle.
The jobs in a bundle are accounted separately under the account ID of the original
jobs.
All the jobs in the bundle must have the same output location. Otherwise, the operator
panel displays a warning message. To continue, you must first split the bundled job,
then change the individual job settings and finally bundle the jobs again.
Main actions on the bundle function
The table below describes the main actions you can carry out with regard to the bundle
function.
Main bundle functions
Main actions
'Bundle'
#
Description
When you touch 'Bundle' after selecting 2 or more jobs, a
new job is created that contains the original jobs. The new
job is added to the bottom of the list of 'Waiting jobs'. The
original jobs are removed from the list. The new job gets
a new name that is based on the name of the first job in
the bundle.
Combine jobs
Chapter 6 - Print jobs 155