Adjustment - Canon imagePRESS C7010VPS Operating Information Manual

Calibrate the printer - '2. Auto gradation adjustment'
Introduction
The 'Shading correction performed successfully - values stored' procedure is a precise
calibration of the gradation, density and color settings of the printer. A test print is used
to scan and to correct the irregularities automatically. The auto gradation adjustment is
part of the complete calibration procedure. However, you can perform an auto gradation
procedure separately.
You are advised to run the 'Shading correction performed successfully - values stored'
procedure separately after a toner bottle is replaced..
#
NOTE
In case of a full system calibration, make sure you use media from the same batch for
'1. Shading correction' and '2. Auto gradation adjustment'.
When to do
Immediately after the '1. Shading correction' procedure is finished.
The '2. Auto gradation adjustment' procedure is part of the complete calibration procedure.
Before you begin
Make sure you use one of the following media.
Canon CS-814 81.4 g/m²
Océ Top Colour FSC 100 g/m²
Mondi Neusiedler 100 g/m²
International Paper Hammermill 105 g/m²
Calibrate the printer - '2. Auto gradation adjustment'
From the 'Calibration method' window, select 'Automatic (internal sensor)' and touch
1.
'OK'.
An instruction window opens.
Wait a few minutes while the printer performs the '2. Auto gradation adjustment'.
Remove the test prints.
2.
Touch 'Next' to continue with the 'Gradation adjustment performed successfully - values
3.
stored' procedure.
Calibrate the printer - '2. Auto gradation adjustment'
Chapter 11 - Maintenance and calibration 347