Engine Maintenance; Inspecting The Carbon Canister Air Filter; Servicing The Air Cleaner; Changing The Engine Oil And Filter - Toro Workman HD 07369 Operator's Manual

Engine Maintenance

Inspecting the Carbon Canister
Air Filter
Service Interval: After the first 50 hours
Every 200 hours
1. Locate the air filter on the bottom of the carbon
canister (Figure 37).
1
Figure 37
1. Filter opening
2. Ensure that the opening on the bottom of the filter is
clear and open.

Servicing the Air Cleaner

Service Interval: Every 50 hours—Clean and oil the
air cleaner foam pre-cleaner. (Every
25 hours if operating conditions are
extremely dusty or sandy)
Every 50 hours—Inspect the air cleaner paper element.
Every 200 hours
1. Remove the knob, O-ring, and cover (Figure 38).
1. Knob and O-ring
2. Air cleaner cover
3. Wing nut
4. Inner cover
2. Remove the foam pre-cleaner by sliding it off of the
G016089
3. Install the foam pre-cleaner onto the paper element.
4. Install the element with the pre-cleaner, breather seal,
5. Tighten the knob 1/2 to 1 turn after knob contacts the
Changing the Engine Oil And
Filter
Service Interval: After the first 50 hours
35
Figure 38
paper element, and clean it as follows:
A. Wash the foam pre-cleaner in detergent and warm
water.
B. Wrap the foam pre-cleaner in cloth and press dry.
Do not wring the pre-cleaner. Allow it to air dry.
C. Saturate the foam pre-cleaner in clean engine oil.
Press it to remove any excess oil.
Do not wash the paper element or clean it with
compressed air, as damage will occur.
Note: With the air cleaner disassembled, check the air
cleaner components for damage. Replace and damaged
parts.
inner cover, wing nut, air cleaner cover, O-ring, and
knob.
cover. Do not overtighten.
Every 100 hours
5. Breather seal
6. Foam pre-cleaner
7. Paper element