Maintaining The Machine Under Special Operating Conditions; Pre-Maintenance Procedures; Preparing The Machine For Maintenance; Using The Bed Support - Toro Workman HDX-D Operator's Manual

Maintaining the Machine under Special Operating
Conditions
Important:
If the machine is subjected to any of the conditions listed below, perform maintenance
twice as frequently:
•
Desert operation
•
Cold climate operation—below 10°C (50°F)
•
Trailer towing
•
Frequent operation in dusty conditions
•
Construction work
•
After extended operation in mud, sand, water, or similar dirty conditions, do the following:
– Have your brakes inspected and cleaned as soon as possible. This prevents any abrasive material
from causing excessive wear.
– Wash the machine using water alone or with a mild detergent.
Important:
Do not use brackish or reclaimed water to clean the machine.
Pre-Maintenance
Procedures
Many of the subjects covered in this maintenance
section require raising and lowering the bed. To
prevent serious injury or death, take the following
precautions.
Preparing the Machine for
Maintenance
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Empty and raise the cargo bed; refer to
the Cargo Bed (page
4. Shut off the engine and remove the key.
5. Allow the machine to cool before performing
maintenance.

Using the Bed Support

Important:
Always install or remove the bed
support from the outside of the bed.
1. Raise the bed until the lift cylinders are fully
extended.
2. Remove the bed support from the storage
brackets on the back of the ROPS panel
21).
Raising
25).
(Figure
1. Bed support
3. Push the bed support onto the cylinder rod, and
ensure that the support-end tabs rest on the
end of the cylinder barrel and cylinder-rod end
(Figure 22).
35
Figure 21
g026142