Securing through-loading bag and skis
›
Tighten the strap
around the skis in front of the bindings
A
strap must hold the skis tight.
›
Fold the seat backrest a little forward
›
Guide the securing strap
through the opening in the seat backrest around
B
the upper part of the seat backrest.
›
Then, fold the seat backrests back until the locking button clicks into place.
Check this by pulling on the seat backrest.
›
Insert the securing strap
into the lock
B
WARNING
The total weight of the skis which are transported must not exceed 24
■
kg.
Always stow and secure the skis and the bag securely - otherwise there is
■
a risk of injury or accident!
Electrical sockets
Introduction
WARNING
Do not place anything on the dashboard. These objects might slide or fall
■
down when driving and may distract you from concentrating on the traffic
– risk of accident!
Make sure that while driving no objects can enter the driver's footwell -
■
cause an accident!
Safely stow all devices during the journey to prevent them from being
■
thrown around the interior in the event of a sudden braking manoeuvre or
an accident – risk of death!
The devices may warm up during operation – risk of injury or fire!
■
Improper use of the power sockets and the electrical accessories can
■
cause fires, burns and other serious injuries.
The 12-Volt sockets also work if the ignition is switched off. When leaving
■
the vehicle, never leave persons who are not completely independent, such
as children, unattended in the vehicle.
» Fig.
121. The
» page
84.
until it clicks into place.
C
CAUTION
When using the 12 volt power outlets the following notes are to be observed.
The sockets can only be used for the connection of approved electrical ac-
■
cessories with a total power consumption of up to 120 watts, otherwise the
electrical system of the vehicle may be damaged.
Connecting appliances when the engine is not running will drain the battery
■
of the vehicle!
Before switching the ignition on / off or before starting the engine, switch
■
off the devices which are connected to the sockets - there is a risk of damage
to the equipment due to voltage fluctuations.
12-volt socket in the front centre console
Read and observe
and
›
To use, open the storage compartment, remove the cover of the socket
» Fig. 122
and plug the electrical appliance plug into the socket.
Fig. 122
Cover of the 12 volt power out-
let
on page 97 first.
Practical features
97