Data connection
Internet connection
Infotainment Columbus
Fig. 207 WLAN (Wi-Fi) / Bluetooth® / SIM card
Possible connection types
» Fig. 207
Using WLAN, by connecting the Infotainment system to the hot spot of
A
the external device
» page
171, Connect Infotainment to the hotspot of
the external device.
By connecting to a mobile phone (it is connected to the Internet) using the
B
®
Bluetooth
rSAP profile
» page
®
Bluetooth
rSAP profile.
C
Using a SIM Card with a data tariff
using a SIM card in the external module.
170, Establishing a connection using the
» page
170, Establishing a connection
Connecting Infotainment Amundsen
Fig. 208 WLAN (Wi-Fi) / CarStick
Possible connection types
» Fig. 208
Using WLAN, by connecting the Infotainment system to the hot spot of
A
the external device
» page
171, Connect Infotainment to the hotspot of
the external device.
Using the CarStick USB device
B
Connecting via the CarStick device
Applies to Infotainment Amundsen.
The CarStick USB device can be purchased from the original accessories.
›
Insert a SIM card with activated data services into the CarStick device.
The required dimensions of the SIM card can be found in the instructions en-
closed with the CarStick ŠKODA original accessory.
›
Turn on the ignition and switch on Infotainment.
›
Insert the CarStick into the USB input at the front
›
Wait approximately one minute until the red light on Carstick stays continu-
ously lit (if the red lights up, then disconnect and re-insert the Carstick).
›
If the SIM card is protected by a PIN code, then the PIN code of the SIM card
must be entered.
›
Confirm the entered PIN code by tapping .
›
or: the function surface to save and confirm the PIN code.
›
If necessary, set the required network of the data service provider.
» page
169.
» Fig. 103
on page 91,
Data connection
169