Speed Limiter - Skoda SUPERB Owner's Manual

After the start of the regulation, the CCS regulates the vehicle to the current
speed and the warning light illuminates in the instrument cluster.

The automatic control interruption occurs if any of the following conditions
are met.
The brake pedal is operated.
▶
▶ When one of the brake assist systems (e.g. ESC) intervenes.
▶ Through an airbag deployment.
WARNING
Always deactivate the cruise control system after use to prevent the sys-
■
tem being switched on unintentionally.
The control does not resume if the set speed for the existing traffic con-
■
ditions is too high.
Note
During control, speed can be increased by pressing the accelerator pedal. Re-
■
leasing the accelerator pedal will cause the speed to drop again to the set
speed.
By pressing the button D » Fig. 286
■
and the Speed Limiter is activated.

Speed limiter


Introduction
The Speed Limiter limits the maximum driving speed to the set speed limit.
The speed limit can only be exceeded by depressing the accelerator pedal fully.
The condition in which the Speed Limiter prevents a potential set speed limit
excess is referred to as Regulation.
WARNING
The general information relating to the use of assistance systems must be
observed » page 212, in section Introduction.
during the regulation this is cancelled
Function
Fig. 287 Instrument cluster display: examples of speed limiter status
displays

Read and observe on page 231 first.
Speed limiter status displays » Fig. 287
Speed limit is set, control is inactive (in the colour display the digits of

speed limits is shown in grey).
Control active (in the colour display the digits of the speed limits are high-

lighted).
No speed limit set.

System fault - seek assistance from a specialist garage immediately.

Basic requirements for start of control
The Speed Limiter is activated.

The current speed is greater than approx. 30 km/h.

After starting the system, the current speed is set as the speed limit, the warn-
ing light lights up in the instrument cluster.

Exceeding the speed limit during the regulation
If, during the control, it is necessary to exceed the speed limit (e.g. to over-
take), the accelerator pedal must be pressed fully.
When exceeding the speed limit (e.g. driving down a hill), an acoustic signal
sounds and the warning light flashes in the instrument cluster.

The regulation is resumed once the speed has fallen below the set limit.
231
Assist systems