The vehicle speed is over 60 km/h or for some countries more than 40
km/h.
The windscreen is clean in the sensor area.
System on/off
Read and observe
and
Switch on the system
›
Push the lever into the sprung position
light lights up in the instrument cluster display.
Switch off the system
›
If the high beam is switched on automatically, move the lever into the sprung
position
. The warning light goes out. The high beam turns off.
B
›
If the high beam is is not switched on automatically, move the lever into the
sprung position
. The warning light goes out. The high beam turns on.
A
The high beam switches off automatically when the speed falls below 30 km/h
(but the system remains switched on).
Interior lighting
Introduction
The inner lighting also works if the ignition is switched off. With the ignition
off (or after a door is opened),the lights will automatically switch off after ap-
proximately 10 minutes.
Fig. 66
Operating lever: Headlamp as-
sistant
on page 72 first.
» Fig.
66. The following indicator
A
Operation of the lights from the front seats
Switch on/off (by pressing the relevant switch)
Automatic operation
A
Rear lighting
B
Depending on equipment fitted:
C
▶
Reading lamp left
▶
Front and rear lighting
Reading lamp right
D
Automatic operation - switch
The system is turned on when any of the following is present.
The vehicle is unlocked.
▶
One of the doors is opened.
▶
The ignition key is removed.
▶
The system is turned off when any of the following is present.
The vehicle is locked.
▶
The ignition is switched on.
▶
▶
About 30 seconds after all the doors have been closed.
Fig. 67
Operation of the lights from the
front seats
» Fig. 67
Lights and visibility
73