Measure Inside Width (Cycle 425, Din/Iso: G425, Software Option 17); Cycle Run; Please Note While Programming - HEIDENHAIN TNC 620 User Manual

Touch Probe Cycles: Automatic Workpiece Inspection | MEASURE INSIDE WIDTH (Cycle 425, DIN/ISO: G425,
software option 17)
15.9 MEASURE INSIDE WIDTH (Cycle 425,
DIN/ISO: G425, software option 17)

Cycle run

Touch Probe Cycle 425 measures the position and width of a slot
(or pocket). If you define the corresponding tolerance values in the
cycle, the TNC makes a nominal-to-actual value comparison and
saves the deviation value in a system parameter.
1 Following the positioning logic, the TNC positions the touch
probe at rapid traverse (value from FMAX column) (see
"Executing touch probe cycles", Page 339) to touch point 1. The
TNC calculates the touch points from the data in the cycle and
the safety clearance from the SET_UP column of the touch
probe table.
2 Then the touch probe moves to the entered measuring height
and runs the first probing process at the probing feed rate
(column F). The first probing is always in the positive direction of
the programmed axis.
3 If you enter an offset for the second measurement, the TNC
then moves the touch probe (if required, at clearance height)
to the next starting point
If the nominal length is large, the TNC moves the touch probe
to the second touch point at rapid traverse. If you do not enter
an offset, the TNC measures the width in the exact opposite
direction.
4 Finally the TNC returns the touch probe to the clearance height
and saves the actual values and the deviation value in the
following Q parameters:
Parameter number
Q156
Q157
Q166

Please note while programming:

Before a cycle definition you must have programmed a
tool call to define the touch probe axis.
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
2 and probes the second touch point.
Meaning
Actual value of measured length
Actual value of the centerline
Deviation of the measured length
15
451