HEIDENHAIN TNC 620 User Manual page 15

Fundamentals | New and changed cycle functions of software 81760x-04
New and changed cycle functions of software
81760x-04
In the protocol of the KinematicsOpt cycles 451 and 452 the
position of the measured rotary axes can be output before
and after optimization. see "MEASURE KINEMATICS (Cycle
451, DIN/ISO: G451, option)", Page 496, see "PRESET
COMPENSATION (Cycle 452, DIN/ISO: G452, option)",
Page 510
Cycle 225 has been expanded by parameters Q516, Q367 ,
and Q574. This makes it possible to define a preset for the
respective text position, as well as to scale the text length
and character height. The pre-positioning for engraving on a
circular path has changed, see "ENGRAVING (Cycle 225, DIN/
ISO: G225)", Page 317
In Cycles 481 to 483, parameter Q340 was expanded with
the input option "2". This makes it possible to check the tool
without changing the tool table, see "Measuring tool length
(Cycle 31 or 481, DIN/ISO: G481, Option 17)", Page 532, see
"Measuring tool radius (Cycle 32 or 482, DIN/ISO: G482, Option
17)", Page 534, see "Measuring tool length and radius (Cycle
33 or 483, DIN/ISO: G483, Option 17)", Page 536
Cycle 251 has been expanded by parameter Q439. In addition,
the strategy for finishing was revised, see "RECTANGULAR
POCKET (Cycle 251, DIN/ISO: G251, software option 19)",
Page 151
In Cycle 252, the strategy for finishing was revised, see
"CIRCULAR POCKET (Cycle 252, DIN/ISO: G252, software
option 19)", Page 156
Cycle 275 has been expanded by parameters Q369 and Q439,
see "TROCHOIDAL SLOT (Cycle 275, DIN/ISO: G275, software
option 19)", Page 240
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
15