Preset From Inside Of Corner (Cycle 415, Din/Iso: G415, Software Option 17); Cycle Run - HEIDENHAIN TNC 620 User Manual

Touch Probe Cycles: Automatic Presetting | PRESET FROM INSIDE OF CORNER (Cycle 415, DIN/ISO: G415,
software option 17)
14.9 PRESET FROM INSIDE OF CORNER
(Cycle 415, DIN/ISO: G415, software
option 17)

Cycle run

Touch Probe Cycle 415 finds the intersection of two lines and
defines it as the preset. If desired, the TNC can also enter the
intersection into a datum table or preset table.
1 Following the positioning logic, the TNC positions the touch
probe at rapid traverse (value from FMAX column) (see
"Executing touch probe cycles", Page 339) to touch point
figure at upper right) that you have defined in the cycle. The
TNC offsets the touch probe by the safety clearance in the
direction opposite to the respective traverse direction.
2 Then the touch probe moves to the entered measuring height
and runs the first probing process at the probing feed rate
(column F). The probing direction is derived from the number by
which you identify the corner.
1 Then the touch probe moves to the next starting position
from there probes the second position.
2 The TNC positions the probe to starting point
starting point 4 to probe the third and fourth touch points.
3 Finally the TNC returns the touch probe to the clearance height
and processes the determined preset depending on the cycle
parameters Q303 and Q305 (see "Characteristics common to
all touch probe cycles for presetting", Page 370) and saves the
coordinates of the determined corner in the Q parameters listed
below.
4 If desired, the TNC subsequently measures the preset in the
touch probe axis in a separate probing.
Parameter number
Q151
Q152
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
and then to
3
Meaning
Actual value of corner in reference axis
Actual value of corner in minor axis
1 (see
2 and
14
403