HEIDENHAIN TNC 620 User Manual page 406

14
Touch Probe Cycles: Automatic Presetting | PRESET FROM INSIDE OF CORNER (Cycle 415, DIN/ISO: G415,
software option 17)
Q303 = 0: The TNC writes to the datum table. The
datum is not automatically activated
Q331 New preset in reference axis? (absolute):
Coordinate in the reference axis at which the TNC
should set the corner. Default setting = 0. Input
range -99999.9999 to 99999.9999
Q332 New preset in minor axis? (absolute):
Coordinate in the minor axis at which the TNC
should set the corner. Default setting = 0. Input
range -99999.9999 to 99999.9999
Q303 Meas. value transfer (0,1)?: Specify
whether the determined preset is to be saved in
the datum table or in the preset table:
-1: Do not use! Is entered by the TNC when
old programs are read in (see "Characteristics
common to all touch probe cycles for presetting",
Page 370)
0: Write the measured preset into the active
datum table. The reference system is the active
workpiece coordinate system
1: Write the measured preset into the preset table.
The reference system is the machine coordinate
system (REF system).
Q381 Probe in TS axis? (0/1): Specify whether
the TNC should also set the preset in the touch
probe axis:
0: Do not set the preset in the touch probe axis
1: Set the preset in the touch probe axis
406
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017