Preset At Center Of 4 Holes (Cycle 418, Din/Iso: G418, Software Option 17); Cycle Run - HEIDENHAIN TNC 620 User Manual

14
Touch Probe Cycles: Automatic Presetting | PRESET AT CENTER OF 4 HOLES (Cycle 418, DIN/ISO: G418,
14.12 PRESET AT CENTER OF 4 HOLES (Cycle
418, DIN/ISO: G418, software option 17)

Cycle run

Touch Probe Cycle 418 calculates the intersection of the lines
connecting opposite holes and sets the preset at the intersection.
If desired, the TNC can also enter the intersection into a datum
table or preset table.
1 Following the positioning logic, the TNC positions the touch
probe at rapid traverse (value from FMAX column) (see
"Executing touch probe cycles", Page 339) to the center of the
first hole 1.
2 Then the probe moves to the entered measuring height and
probes four points to find the first hole center.
3 The touch probe returns to the clearance height and then to the
position entered as center of the second hole 2.
4 The TNC moves the touch probe to the entered measuring
height and probes four points to find the second hole center.
5 The TNC repeats steps 3 and 4 for holes
6 Finally the TNC returns the touch probe to the clearance height
and processes the determined preset depending on the cycle
parameters Q303 and Q305 (see "Characteristics common
to all touch probe cycles for presetting", Page 370). The TNC
calculates the preset as the intersection of the lines connecting
the centers of holes
the Q parameters listed below.
7 If desired, the TNC subsequently measures the preset in the
touch probe axis in a separate probing.
Parameter number
Q151
Q152
414
3 and 4.
1/3 and 2/4 and saves the actual values in
Meaning
Actual value of intersection point in
reference axis
Actual value of intersection point in
minor axis
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
software option 17)