Touch Probe Cycles: Automatic Presetting | PRESET CIRCLE CENTER (Cycle 416, DIN/ISO: G416, software
option 17)
Please note while programming:
Danger of collision!
Cycles for coordinate transformation must not be active during
execution of the touch probe cycles.
Do not activate the following cycles before using touch probe
cycles: Cycle 7 DATUM SHIFT,Cycle 8 MIRROR IMAGE, Cycle
10 ROTATION,Cycle 11 SCALING and 26 AXIS-SPECIFIC
SCALING
Reset any coordinate transformations beforehand
Before a cycle definition you must have programmed a
tool call to define the touch probe axis.
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
NOTICE
14
409