HEIDENHAIN TNC 620 User Manual page 22

3.10 SINGLE-LIP DEEP-HOLE DRILLING (Cycle 241, DIN/ISO: G241, software option 19)...................101
Cycle run.............................................................................................................................................. 101
Please note while programming:......................................................................................................... 102
Cycle parameters................................................................................................................................. 103
Position behavior when working with Q379........................................................................................105
3.11 Programming Examples.................................................................................................................... 109
Example: Drilling cycles....................................................................................................................... 109
Example: Using drilling cycles in connection with PATTERN DEF.......................................................110
22
HEIDENHAIN | TNC 620 | User's manual for cycle programming | 10/2017
Contents