Omron E5CC User Manual page 233

w1 to 8on
w1 to 8of
• ON Delay
When the results of a work bit logic operation is ON, the work bit is turned ON after the
time specified in the parameter elapses.
Function
• OFF Delay
When the results of a work bit logic operation is OFF, the work bit is turned OFF after the
time specified in the parameter elapses.
Setting
Related Parameters
See
See
Auxiliary Output 1 to 4 Assignment (Advanced Function Setting Level): Page 6-79
plcm
• The Communications Monitor parameter displays the communications cycle time of the
E5@C.
• If communications are not possible with the PLC, c.err is displayed. When
Function
communications are restored, the cycle time is displayed again.
Normal: 0 to 9999 ms, If 9999 ms is exceeded: ]]]]
Setting
Error: c.err
Refer to the E5
H175) for information on communications.
E5@C Digital Temperature Controllers User's Manual (H174)
000
Work Bit 1 to 8 ON Delay
Work Bit 1 to 8 OFF Delay
Setting range
0 to 999 Seconds
Communications Monitor
Monitoring range
@
C Digital Temperature Controllers Communications Manual (Cat. No.
The work bit operation type must not be set to OFF.
000
Unit Default
0
Communications must be supported.
The Protocol Setting parameter must be set to Host
Link (FINS) or the MC Protocol.
6 Parameters
Default
---
6
6 - 37