Omron E5CC User Manual page 196

5 Advanced Operations
5 - 68
3. Select Library 1 from the
library list, and then click the
OK Button.
Confirm the following
settings, and then click the
OK Button.
Work bit 1 operation type:
Operation 1
Work bit 1 input assignment
A = 7: Alarm 1
Work bit 1 input assignment
B = 19: Invert for RUN/STOP
Work bit 1 input assignment
C = 0: Always OFF
Work bit 1 input assignment
D = 0: Always OFF
Auxiliary output 1 = Work bit
1
4. Closing the Logic Operation
Editor Dialog Box
Click the Close Button.
This completes the
procedure for setting
parameters using the
CX-Thermo. Transfer the
settings to the Controller to
set the Controller. Refer to
CX-Thermo help for the
procedure to transfer the
settings.
E5@C Digital Temperature Controllers User's Manual (H174)