Pic Test Section 5 - HP Series 37 Reference Manual

Error Codes
PIC Test Section 5
Test PIC registers 4
&
5 by reading and writing data. Functions are not tested.
Code Error
0501 Register 4 fails to show data patterns $OOAA.
0502
Register 5 fails to show data patterns $OOAA.
0503
Register 4 fails to show data patterns $0055.
0504
Register
5
fails to show data patterns $005
S.
PIC Test Section 6
Test PIC register 6 (HPIB control register).
Code Error
0601 Register 6 fails to show patterns $802A for Read/Write test.
0602
Register 6 fails to show patterns $4054 for Read/Write test.
0603
Bits 12 and 14 of the ABllnterrupt Register (PIC register
2)
should
be
set (outbound FIFO NOT full and idle).
0604
Bits 12 and 14 of the ABI Interrupt Register (PIC register 2)
should
be
clear (outbound FIFO full and NOT idle).
0605
Bit I 5 of Register 6 should
be
set (clear outbound FIFO) via
the ABI Interrupt Register test. Bits 12 and 14 of the ABI
Interrupt Register should
be
clear.
PIC Test Section 7
Test PIC register 7 (HPIB lIddress).
Code Error
0701
Register 7 fails to show patterns $800A for Read/Write test.
0702 Register 7 fails to show patterns $4015 for Read/Write test.
0703
Bit 9 of Reg 7 should
be
set (Talk always) via the ABI Status
Register (PIC reg
I)
test. Bits 13 or 14 of the ABI Status
Register should
be
off to indicate NOT a Talk or a Listen.
0704 Bit lOaf Reg 7 should be set (Listen always) via the ABI
Status Register test. Bit 13 of the ABI chip Status
Register must
be
on to indicate a Talk always.
0705
Same as 0704 except bit 14 of the ABI chip Status Register
must
be
off to indicate NOT a Listen always.
0706
Same as 0704 except the ABI Status Register is again updated
and bit 13 of the ABI Status Register must be on
NOV 84
A-6
to indicate NOT a Listen always.