Table of Contents
Advertisement
Operating Instructions
17) TICDIAG prompts fer the ft . . . !B tests to be run.
ENTER AlB TESTS TO BE RUN: DEFAULT
THE LAST SET OF TESTS RUN, IF ANY)
The possible tests are:
PCC SELF TEST (PCCS)
PCC DUMP (PCCD)
MCC SELF TEST (MCCS)
MCC DUMP (MCCD)
PCC MCC COMMUNICATION (PCCM)
DIAGNOSTIC LOOPBACK (D)
BAUD RATE (B)
MODEM SIGNALS (MO)
MSC PORT ADDRESSING (MS)
LOOPBACK (L)
ALL (A)
ALL NO LooPBACK (ALLN)
NONE (N)
(RETURN)
The test names may
be
abbreviated as indicated. You can enter a list of tests, separated by
semicolons.
ALL
indicates that all available AlB tests are to be run.
ALL NO LooPBACK
indicates
all AlB tests are to
be
run, except those that require a loopback hood (Modem Signals test, Modem
Address test, and Loopback test).
NONE
indicates that testing of the AlB is not to be done. Pressing
carriage return in response to this question will cause the last AlB tests specified (if any) to be
retained.
ALL NO LOOP BACK
is the recommended response when using the diagnostic in the field. Enter
ALL
if loopback connectors have been installed.
SEP 84
2-5
Advertisement
Chapters
Table of Contents
