Operating Instructions
2.6 HOW TO CONFIGURE PICDIAG
You can configure and reconfigure the diagnostic according to your needs.
Table 2-1 describes the available PICDIAG commands. Those commands indicated with an asterisk (*)
are part of the default configuration. The PICDIAG provides this information when you enter the
HELP
command.
COMMAND
EEPR*
EEPS*
ENPR*
"",AfT
GO
LOOP
NOLOOP
NOTRACE
PRINTER
RST
RUN
SEPS
SNPR
STATE
TEST
TRACE
* default
Table 2-1. DIAGNOSTIC COMMANDS
PARAMETERS
DESCRIPTION
Enable Error Messages
Enable Error Pause
Enable non -error messages
Return to DUS
Resume diagnostic execution
Loop on selected steps
Stop Loop
Suppress I/O trace
Display errors on printer
Enable pauses and messages
also suppress printer
Restart diagnostic execution
Suppress error pauses
Suppress non -error messages
List status of program
step(s)
Select test steps to run
Enable I/O activity trace
SEP 84
2-5