Tape; Test - HP Series 37 Reference Manual

Command Descriptions
The START is performed with the normal operator (Il'ITIAL) dialogue, allowing for changes to the
software configuration or selection of W ARMST AR T.
The correct syntax for this command is:
ST[art] [chan ,device] [{P[erm]}, {C[hange]}]
Tape
The TAPE command operates exactly like the LOAD command with the following exceptions:
• No
channel
or
device
parameters are allowed .
., The default LOAD device is always used .
.. This command is run with the normal operator (INITIAL) dialogue allowing for changes to
the software configuration.
The correct syntax for this command is:
TA[pe]
Test
The TEST command transfers control to the Self Test E<:ecutive which displays all of the Self Test
capabilities and the Test Mode prompt.
If software was running when Maintenance Mode was entered, the operator will be prompted with "Do
you want to abo rt the system? (yiN )". If a "Y" is entered, (or software was not running) then the
Test Executor module is loaded and control is transferred to the Test Mode entry point in the Test
Executor module. If not confirmed, control is transferred back to Maintenance Mode.
The Test Mode entry point in the Test Executor module displays the ROM version numbers, the commands
available in Test Mode, and the "Test -)" prompt. The following commands are allowed in Test Mode:
AL[l] [ count]
CH[an] [count [ ,chan] ]
CP[u] [ count]
E[xit]
H [elp]
I [omap] [ count]
M[emory] [ count
PON [ count ]
For more details, refer to "TEST MODE COMMANDS" latter in this sectioIl.
NOV 84
3-7