Table of Contents
Advertisement
Operating Instructions
18) If any AlB tests are selected, you are prompted for the numbers of the ports that need to be tested.
Those ports which still have devices attached to them should not be selected. If the console is on the
TIC under test, port 0 cannot be specified.
ENTER
PORTS TO BE TESTED: (DEFAULT
THE LAST SET OF PORTS TESTED)
Ports to be tested are specified by selecting a list of the port numbers. The format is:
<integer>{/ <integer> I,<integer>[/ <integer>
J, ... J
If the list of ports is omitted, the last set of ports that you selected will be tested. The lists of ports
can include individual numbers and ranges of numbers.
For example: 1/3,5,7 would
be
a valid list of numbers. It would specify that ports 1,2,3,5, and 7 are
to be tested.
19) TICDIAG then proceeds to test the TIC PCA. Upon completion, a message is displayed. During the
executi0l!- of the TICDIAG, the messages specified by you ar' printed to the list device.
TESTING COMPLETED.
CHANNEL/LOOP COUNT/OUTPUT CHANGES
(DEFAULT
=
NO)?
You can run the test again and change the parameters by resJ.'onding
YES
and then answering the
prompts.
SEP 84
2-6
Advertisement
Chapters
Table of Contents
