Table of Contents
Advertisement
Chapter 6 Trunk Spans and Dialing Rules
DIALED_DIGITS_ANI
DISABLED_TRUNKS
DISPLAY_IE_TAG
DOWNLOAD_BOARDS
INBOUND
Note:
This keyword is generally
NOT used. The Call Manager
or Gateway normally assigns
trunks to be used as Inbound
Trunks.
INTL_WATT
Page 6-10
This document is confidential and proprietary to SER Solutions and is not for external use.
This keyword is reserved for Engineering and should NEVER be modified
unless instructed to do so by Engineering. The default value for this keyword
is zero.
This keyword indicates that dialed digits are to be placed in the ANI field
when the call is launched. This was needed when dialing through the Aspect
switch.
This keyword specifies a trunk or range of trunks that are considered dis-
abled. As disabled trunks, they will not be used for dialing, and error reports
on them will NOT be sent to the Call Manager. This keyword is generally
used to disable trunks that are expected to be out-of-service permanently or
for an extended period of time.
Trunks can be entered either as individual numbers, or ranges.
Example:
DISABLED_TRUNKS 3 5 17-29
This keyword specifies a tag to be inserted into the Display IE for delivering
Caller ID Name. Nortel requires a 0xB1. AT&T on a 4e wants no tag. Note:
The value associated with the keyword must be entered as decimal.
Example: For a hex B1, enter the following:
DISPLAY_IE_TAG
This keyword indicates whether the NMS boards should be downloaded with
firmware prior to starting the TSP application. This keyword should always
be set to one unless instructed by engineering to change it.
This keyword specifies a trunk or range of trunks that are considered Inbound
only trunks. Trunks can be entered either as individual trunks, or ranges.
Example:
INBOUND 3 17-19
This keyword specifies a trunk group preferred for use when dialing Interna-
tional telephone numbers. This is a trunk preference, and not a guaranteed
Version 4.0
177
CPSEE_TSP500 User Guide
Advertisement
Table of Contents
