Span - Avaya CPSEE_TSP500 User Manual

SPAN

CPSEE_TSP500 User Guide
This document is confidential and proprietary to SER Solutions and is not for external use.
Table 5-24: SLOTS Command
Command
Sl
Type
Protocol
Trunks
Alarm
RD
BL
YL
SL
TO
EC
NA
BPV
LSY
FE
LOS
At the end for each line may appear a R_LOOP or L_LOOP if the span is in
some form of loopback mode.
This command is used to control the state of ISDN channels. Currently
unavailable because features of this command are not fully supported by the
TSP's board venter (NMS).
Version 4.0
Chapter 5 Admin Terminal Commands
Description
Slot (Span) Number. An "*" indicates this span is
the Clock Master.
T = Trunk D = Digital Station.
For ISDN lines another 'D" next to the 'T' or 'D'
indicates the D channel is down.
Example:
T Trunk (if ISDN, D-Channel is UP)
D Digital Station (if ISDN, D-Channel is UP)
TD Trunk – D-Channel is DOWN.
DD Digital Station – D-Channel is DOWN
Network protocol loaded into the firmware.
Trunk Numbers associated with this span.
Displays current Alarms R = RED, Y = YELLOW, B
= BLUE, L = Loss of Signal.
Historic count of RED alarms.
Historic count of BLUE alarms.
Historic count of YELLOW alarms.
Count of slips.
Count of timeouts that occurred on this span.
Count of times error detection threshold was
exceeded.
Not applicable at this time.
Count of Bipolar Violations.
Count of Loss of Synchronization.
Count of Framing Errors.
Count of Loss of Signal indications.
Page 5-37