Table of Contents
Advertisement
AUTO_LOG
Caution!
This equates to "bug 13f"
With this flag turned on, cer-
tain Admin_Terminal com-
mands may appear not to
work. However, it is possible
that the output (that would
normally go to the screen)
may be going to the log files.
You can turn logging off via
the "log" command. You may
first want to type "bug 0" to
prevent all the BUG mes-
sages from flooding the
screen.
CALLING_NUMBER
Note:
Caller ID Text can only be
assigned by CPS Enterprise
Edition. There is no keyword
that assigns a default.
CLOCK_MASTER
CLOCK_POLL
CONN_THREAD
COUNTRY
CPSEE_TSP500 User Guide
This document is confidential and proprietary to SER Solutions and is not for external use.
If non-zero, it instructs the TSP to automatically log events. The value is the
decimal equivalent of the hexadecimal value of the bug setting. A typical set-
ting would be
AUTO_LOG 319
:
This keyword defines a global originating number to be sent as Caller ID
information over ISDN lines. The TSP allows originating information to be
sent on a dial-by-dial basis, campaign basis, and a globally-assigned basis.
The precedence is:
1. Number by Number
2. Campaign Assigned
3. Global Assignment
The number assigned by this keyword can be overwritten by the Call Man-
ager or Gateway (and usually is).
This keyword specifies the span to be designated the Primary Clock.
This keyword specifies (in seconds) the time to wait between processing
clocking information. The default is five seconds, which should not be
changed unless advised to do so by Engineering.
This keyword is reserved for Engineering and should NEVER be modified
unless instructed to do so by Engineering. The default value for this keyword
is zero.
Version 4.0
Chapter 6 Trunk Spans and Dialing Rules
Page 6-7
Advertisement
Table of Contents
