Chrysler 2000 LHS Owner's Manual page 1510

2000 LHS, 300M, CONCORDE AND INTREPID
LH
REMOVAL AND INSTALLATION (Continued)
1 – FRONT SEAT BACK PANEL
2 – LEFT SEAT AIRBAG MODULE
3 – HOLE PROVIDED IN SEAT BACK FOAM FOR SEAT AIRBAG
MODULE
4 – SIDE AIRBAG MODULE NYLON SLEEVE
Fig. 2 Negative Battery Cable Remote Terminal
1 – RIGHT STRUT TOWER
2 – AIR CLEANER INLET TUBE
3 – REMOTE TERMINAL
Fig. 3 Front Seat Retaining Bolts
1 – FRONT BOLTS
2 – REAR BOLTS
5 – SEAT BACK TRIM COVERS
6 – SEAT BACK CUSHIONS
7 – SEAT BACK FRAMES
8 – RIGHT SEAT AIRBAG MODULE
(4) Remove bolts attaching front of the seat track
to floor kick up (Fig. 3).
(5) Tilt seat upward to access and disconnect the
front seat wire harness connector from body harness
connector.
(6) Disconnect airbag wire harness connector by
first sliding connector lock to the "unlocked" position,
then depress connector retaining tab and pull
straight apart.
(7) Remove front seat from vehicle.
INSTALLATION
(1) Place front seat in position in vehicle.
(2) Connect front seat wire harness connector to
body harness connector.
(3) Connect airbag wire harness connector. Be cer-
tain airbag connector is secure and locking tab is in
the "locked" position before installing seat retaining
bolts.
(4) Install bolts attaching the front of seat track to
the floor kick up. Tighten bolts to 61 N·m (45 ft. lbs.)
torque.
(5) Install bolts attaching rear of seat track to the
floor. Tighten bolts to 61 N·m (45 ft. lbs.) torque.
(6) Connect the remote negative battery cable.
(7) Using the DRB III Scan Tool erase all DTC's
and perform airbag system diagnostics.
(8) Verify front seat operation.
FRONT SEAT CUSHION SIDE SHIELD - AIRBAG
EQUIPPED
REMOVAL
WARNING: DISCONNECT AND ISOLATE THE NEG-
ATIVE BATTERY CABLE
BEFORE BEGINNING ANY FRONT SEAT REMOVAL
OR INSTALLATION PROCEDURE. THIS WILL DIS-
ABLE THE AIRBAG SYSTEM. FAILURE TO DISCON-
NECT THE BATTERY
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
WARNING: ONCE THE NEGATIVE CABLE IS DIS-
CONNECTED WAIT FOR 2 MINUTES BEFORE
REMOVING ANY AIRBAG SYSTEM COMPONENTS.
(1) Disconnect and isolate the remote negative bat-
tery cable.
BODY 23 - 3
REMOTE TERMINAL
COULD RESULT IN