Chrysler 2000 LHS Owner's Manual page 1395

23 - 44 BODY
REMOVAL AND INSTALLATION (Continued)
(2) Install speaker to front door flag enclosure
cover, if necessary.
(3) Install fasteners attaching the front door flag
enclosure cover to the door.
Fig. 30 Front Door Flag Enclosure Cover and Plate
1 – FRONT DOOR W/O SPEAKER COVER
2 – FRONT DOOR ENCLOSURE PLATE
3 – FRONT DOOR WITH SPEAKER COVER
FRONT DOOR TRIM PANEL
REMOVAL
CAUTION: Do not pry on door trim panel, damage
to trim panel will result.
(1) Remove speaker flag.
(2) Remove speaker grille by inserting trim tool at
the rear of the grille and disengaging clips holding to
trim panel. Remove grille (Fig. 31).
(3) Remove trim plug from the pull cup and
remote bezel by inserting a small flat blade tool into
the notch and remove.
(4) Remove three screws from bottom of door.
(5) Remove screw in pull cup.
(6) Remove screw in remote bezel.
(7) Remove two screws in the instrument panel
interface area.
(8) Remove three screws in the speaker area.
(9) Using an trim tool, disengage the retainer clips
from the door trim panel to the door panel.
(10) Raise trim panel up to disengage from the
belt being careful to hold the panel securely.
(11) Disconnect the linkage from the remote han-
dle assembly (Fig. 32).
(12) Disconnect the power mirror switch.
(13) Disconnect the power door lock switch wire
connector.
(14) Disconnect the power window switch wire con-
nector.
(15) Disconnect the radio speaker wire connector.
(16) Disconnect wiring harness clips from trim
panel.
(17) Disconnect the courtesy lamp.
(18) Remove trim panel from vehicle.
Fig. 31 Front Door Trim Panel – Typical
1 – REMOTE BEZEL
2 – I/P INTERFACE
3 – SCREWS
4 – SPEAKER GRILLE
5 – PULL CUP
INSTALLATION
(1) Place door trim panel in position.
(2) Install wire harness clips into door trim panel.
(3) Connect the courtesy lamp.
(4) Connect the radio speaker wire connector.
(5) Connect the power window switch wire connec-
tor.
(6) Connect the power door lock switch wire con-
nector.
(7) Connect the power mirror switch wire connec-
tor.
(8) Connect the linkage to the handle assembly.
(9) Install the water shield. Ensure that the water
shield locator holes align. Ensure that the shield is
sealed.
(10) Insert trim panel into channel retainer at top
door.
(11) Insert the forward four way alignment guide
into position. Insert the rearward two way alignment
guide into position.
LH