Chrysler 2000 LHS Owner's Manual page 1402

LH
REMOVAL AND INSTALLATION (Continued)
(1) Install double ended stud into the door frame.
Tighten the double ended stud to 14 N·m (120 in.
lbs.) torque.
(2) Install hinge. Tighten the hinge bolt and nut to
28 N·m (250 in lbs.) torque.
(3) Verify door alignment and operation, adjust as
necessary.
Fig. 44 Door Hinge Double Ended Stud
1 – DOUBLE ENDED STUD
2 – NUT
FRONT DOOR BODY MOUNTED
WEATHERSTRIP
REMOVAL
(1) Open front door.
(2) Remove door opening sill plate.
(3) Pull body mounted weatherstrip from fence
around door opening (Fig. 45).
Fig. 45 Front Door Body Mounted Weatherstrip
1 – FRONT DOOR OPENING
2 – FRONT DOOR BODY MOUNTED WEATHERSTRIP
3 – PINCH FLANGE
INSTALLATION
(1) Position color dot on weatherstrip at the B-pil-
lar upper corner.
(2) Engage weatherstrip on the fence at upper
B-pillar and work down the B-pillar.
(3) Engage weatherstrip along the header and
down the A-pillar.
(4) Engage weatherstrip along the sill. There may
be slack material work it to the front of the opening.
(5) Verify weatherstrip sealing.
FRONT DOOR MOUNTED WEATHERSTRIP
REMOVAL
(1) Open front door.
(2) Using a fork type prying tool, disengage push
in fasteners attaching weatherstrip to lower door
(Fig. 46).
(3) Remove weatherstrip from door.
Fig. 46 Front Door Mounted Weatherstrip
1 – FRONT DOOR
2 – PUSH-IN FASTENERS
INSTALLATION
(1) Place door mounted weatherstrip in position.
(2) Engage push in fasteners to attach weather-
strip to lower door.
(3) Verify door alignment and seal
REAR DOOR TRIM PANEL
REMOVAL
CAUTION: Do not pry on door trim panel, damage
to trim panel will result.
(1) Remove trim plug from the pull cup and
remote bezel by inserting a small flat blade tool into
the notch and remove, if equipped (LHS/300M).
(2) Remove screw in the pull cup.
(3) Remove screw in remote bezel.
BODY 23 - 51