Chrysler 2000 LHS Owner's Manual page 1397

23 - 46 BODY
REMOVAL AND INSTALLATION (Continued)
OUTSIDE FRONT DOOR HANDLE
REMOVAL
(1) Remove door trim panel.
(2) Remove water shield as necessary.
(3) Remove door glass.
(4) Disengage clips holding latch release link and
lock link to door at latch.
(5) Disconnect links from latch.
(6) Remove screws attaching handle to door
through access hole in door inner pane (Fig. 34).
(7) Remove door handle from door.
Fig. 34 Outside Front Door Handle
1 – FRONT DOOR
2 – DOOR HANDLE
INSTALLATION
(1) Place door handle in position on door.
(2) Install screws to attach to handle to door.
(3) Insert links into clips on latch.
(4) Engage clips to attach latch release link and
lock link to door latch.
(5) Verify door latch handle operation.
(6) Install door glass.
(7) Install water shield.
(8) Install door trim panel.
DOOR LOCK CYLINDER
REMOVAL
(1) Remove door trim panel.
(2) Remove water shield, as necessary
(3) Raise door glass.
(4) Disengage clip holding lock link to lock cylin-
der.
(5) Disconnect link from lock cylinder.
(6) Disconnect clip attaching lock cylinder to door
handle.
(7) Pull lock cylinder from door handle (Fig. 35).
Fig. 35 Door Lock Cylinder
1 – CLIP
2 – LOCK CYLINDER
3 – DOOR HANDLE
INSTALLATION
(1) Push lock cylinder into socket on door handle.
(2) Insert link into clip on lock cylinder.
(3) Engage clip to fasten lock link to lock cylinder.
(4) Verify lock operation.
(5) Install water shield.
(6) Install door trim panel.
LOCK CYLINDERS
Ignition, door, deck lid, and rear hatch lock cylin-
ders are all codable to the key. Lock barrels, tum-
blers, and tumbler springs are available to allow the
technician to change replacement locks cylinders to
match the customer's original key set. See the appro-
priate section in this manual for lock cylinder
removal. See the Mopar catalogue for part numbers
and lock coding procedures.
FRONT DOOR LATCH STRIKER
REMOVAL
(1) Open front door.
(2) Mark location of door latch striker on B-pillar
to assist installation alignment.
(3) Remove bolts holding striker to B-pillar (Fig.
36).
(4) Remove door latch striker from vehicle.
INSTALLATION
(1) Place door latch striker in position on vehicle.
(2) Install bolts to hold striker to B-pillar.
(3) Verify alignment and operation of door, adjust
as necessary.
LH