Chrysler 2000 LHS Owner's Manual page 1405

23 - 54 BODY
REMOVAL AND INSTALLATION (Continued)
REAR DOOR GLASS RUN WEATHERSTRIP
REMOVAL
(1) Remove flag cover, door trim panel, water
shield as necessary, and pull cup support bracket.
(2) Remove door glass.
(3) Pull weatherstrip from lower rear channel
above door latch (Fig. 51).
(4) Pull run weatherstrip from window frame
channel.
INSTALLATION
(1) Clean butyl material from door flange area.
(2) Place door run weatherstrip in position on win-
dow frame channel.
(3) Push door run weatherstrip in position on win-
dow frame channel.
(4) Push weatherstrip into lower rear channel
above door latch.
(5) Install door glass.
(6) Install pull cup support bracket, water shield,
door trim panel and flag trim.
1 – REAR DOOR MOLDING
2 – GLASS RUN
3 – REAR GLASS RUN CHANNEL
Fig. 51 Rear Door Glass Run Weatherstrip
REAR DOOR GLASS REGULATOR
REMOVAL
(1) Remove flag cover, door trim panel, water
shield as necessary, and pull cup support bracket.
(2) Slide glass from regulator roller channel (Fig.
52).
(3) Disconnect power window motor wire connec-
tor.
(4) Loosen screw attaching regulator scissor chan-
nel to door panel.
(5) Remove screw and bolt heads from keyhole
slots in door panel.
(6) Loosen bolt attaching regulator support brace
to door panel.
(7) Loosen bolts attaching regulator to door panel.
(8) Remove regulator from door panel.
(9) Slide regulator rearward and rotate forward
end of roller channel through access hole in door
panel.
INSTALLATION
(1) Insert roller channel through access hole in
door panel.
4 – REAR DOOR
5 – FRONT GLASS RUN CHANNEL
LH