Chrysler 2000 LHS Owner's Manual page 1396

LH
REMOVAL AND INSTALLATION (Continued)
Fig. 32 Inner Front Door Trim Panel – Typical
1 – POWER MIRROR SW.
2 – POWER DOOR LOCK SWITCH
3 – RETAINER CLIPS
4 – COURTESY LAMP
5 – POWER WINDOW SWITCH
6 – WIRE HARNESS CLIPS
(12) Install new retaining clips to attach door trim
panel to door panel.
(13) Install three screws in the speaker area.
(14) Install two screws in the instrument panel
interface area.
(15) Install screw in the remote bezel.
(16) Install screw in pull cup. Tighten screw to 1.7
to 2.3 N·m (15 to 20 in. lbs.) torque.
(17) Install three screws to the bottom of the door.
Tighten screws to 1.7 to 2.3 N·m (15 to 20 in. lbs.)
torque.
(18) Install pull cup and remote bezel trim plug, if
equipped.
(19) Place speaker grille in position on trim panel.
Attach door speaker clips to trim panel.
FRONT AND REAR DOOR WATER DAM
REMOVAL
(1) Remove door trim panel.
(2) Carefully remove by pulling water dam from
door inner panel.
INSTALLATION
(1) Apply an appropriate adhesive/sealant to water
dam edges before installing.
(2) Position water dam on door inner panel.
Ensure that the water dam locator holes align.
(3) Press inward on areas with adhesive to attach
dam to inner door. Ensure that the dam is sealed.
(4) Install trim panel.
FRONT DOOR LATCH
REMOVAL
(1) Close door glass.
(2) Remove door trim panel.
(3) Remove water shield as necessary.
(4) Remove rear glass channel.
(5) Disconnect lock button link from door latch.
(6) Disconnect lock cylinder link from door latch.
(7) Disconnect outside door handle link from door
latch.
(8) Remove screws holding door latch to door end
frame (Fig. 33).
(9) Remove latch from door.
Fig. 33 Front Door Latch
1 – FRONT DOOR
2 – SCREWS
3 – DOOR LATCH
INSTALLATION
(1) Place latch in position in door.
(2) Install screws to hold door latch to door end
frame.
(3) Connect outside door handle link to door latch.
(4) Connect lock cylinder link to door latch.
(5) Connect door lock button link to door latch.
(6) Install rear glass channel.
(7) Verify latch operation.
(8) Install water shield.
(9) Install door trim panel.
BODY 23 - 45