D-Link DXS-3600 Series Cli Reference Manual page 151

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Usage Guideline
None.
Example
This example shows how to change the BFD slow time value.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# bfd slow-timers 1500
Switch(config-if)#
10-4 show bfd
This command is used to display BFD information.
show bfd [interface INTERFACE-ID]
Parameters
interface INTERFACE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the BFD global state and settings on each interface.
Example
This example shows how to display BFD information on all interfaces.
Switch# show bfd
BFD Global State : Disabled
BFD Interface Setting
MinTxInt - Desired Minimum TX Interval
MinRxInt - Required Minimum RX Interval
Interface Name
--------------- ------------ ------------ ---------- -------------
System
n2
n3
n4
(Optional) Specifies to display BFD information on the specified
interface.
MinTxInt(ms) MinRxInt(ms) Multiplier Slow time(ms)
50 50
100 50
100 100
100 50
146
3 2000
4 3000
4 3000
3 1000