Panasonic KX-T336 System Reference Manual page 771

1.02 Group Paging
Description
Allows the attendant to make paging
announcement through built-in speakers of PITS
telephones by specifying the desired Paging
Group.
Up to eight paging groups can be assigned to the
system.
Programming
System Programming
"System-Numbering Plan
(03/11)",
Station Paging
Conditions
Single line telephones (SLT's) can not be paged.
If Tenant Service is employed, paging is only
available within the tenant where the attendant
console belongs.
If the designated paging group is being paged by
another page, busy tone is heard.
However, group paging can be done within the
range not overlapping the previous paging range.
For instance, when paging is being done to group
1, paging groups 2 to 8 are available for new
paging.
If an extension is off-hook or its SP-PHONE is
active, paging is unavailable for the extension.
Current call is parked and Group Paging through
built-in speaker of PITS telephones can be
carried out by pressing the PAGE key during a
conversation.
For further details, refer to Section 6-I-1.05 "Call
Park and Paging."
Operation
1. Press an idle LOOP key and dial
LOOP the feature number for Station
Paging "42" (default) and paging
group number (1 to 8) in
succession.
• Confirmation tone sounds.
The specified paging group
gets ready to be paged.
Reference
VT Dumb
10-C-10.00
9-D-6.03
6-I-2
(70695)
2. Perform paging.
3. An extension answers the page.
4. Press the RELEASE key.
RELEASE
• The call is released from the
attendant console.
Transferring a call using Group Paging
During a conversation,
1. Dial the feature number for
Station Paging "42" (default) and
desired paging group number (1
to 8) in succession.
• Confirmation tone sounds.
The specified paging group
gets ready to be paged.
• The call is held.
2. Perform paging.
3. An extension answers the page.
4. Press the RELEASE key.
RELEASE
• The call is released from the
console.
• Conversation between the held
party and the paged party
starts.