Panasonic KX-T336 System Reference Manual page 501

Hide thumbs Also See for KX-T336:
Table of Contents

Advertisement

1.03 Screened Call Transfer to Trunk
Description
Allows an extension user to transfer a call placed
on the DN or CO button to outside party with
announcement.
To execute this function, assign "System-Class of
Service", CO Transfer mode to "Yes."
If outside call is transferred to another outside
party, CO-CO conversation mode is established
and the duration of the conversation is restricted
by "Group-Trunk Group", CO-CO Duration Limit.
Programming
System Programming
"System-Class of Service (1/2)",
CO Transfer Mode
"Group-Trunk Group (1/2)",
CO-CO Duration Limit
Conditions
If a call from outside party is transferred to
another outside party, CO-CO conversation
mode is established. In this case, the system
uses the preset time limit for the trunk group that
the transferred party is placed on, not using the
time limit for the trunk group used to call the
destination and alarm tone is sent to parties 15
seconds before the assigned time limit, and when
time is out, both CO lines are disconnected.
The extension users can not transfer the
following calls.
• A call on ICM button
• A call with Attendant Console
• A call with Doorphone
• Paging Announcement through built-in
speaker of PITS
If Music on Hold is available, from the start of the
transferring operation until the destination party
answers, the system sends Music on Hold to the
transferred party.
For further detail, refer to Section 3-E-1.00
"Music on Hold."
Reference
VT
Dumb
9-D-4.01
10-C-7.00
9-E-1.01
10-C-14.00
4-F-3
(50195)
Operation
During a conversation with an outside party or an
extension on the DN or CO button
1. Press the TRANSFER button.
• The other party is placed on
Consultation Hold.
• You hear confirmation tone 2
and then dial tone 1 or 3 or 4.
• If your PITS has a display, it
shows:
2. Call another outside party.
• You hear ringback tone from
the CO line.
3. When the destination answers,
make the announcement.
4. Replace the handset or press the
SP-PHONE button.
• The held party and the
destination party start
conversation.
(Supplement)
If an extension that cannot execute this function
by the restriction of COS attempts to do this
procedure, the system sends consultation hold
recall to the extension after step 4 and the
transfer is rejected.
After step 2, you can interrupt the transfer and
talk to the held party again, (1) if the destination
has already answered, by pressing the FLASH
button and the TRANSFER button in succession.
(2) If the destination has not answered yet, by
pressing the TRANSFER button only.
After step 2, you can change the destination by
pressing the FLASH button, and calling a new
outside party.
Transfer to

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents