Panasonic KX-T336 System Reference Manual page 281

(2) What if a call ringing at overflow destination
(ATT/EXT.) is not answered?
CO
UCD group (01-04)
(All Logout)
Overflow destination (ATT/EXT.)
(No answer)
(A)
The call The call will be disconnected
continues to ring.
(A) A call which comes in directly on the overflow
destination* 1 continues to ring on it.
(B) A call which comes in on the overflow
destination after being answered or held
once by the system* 2
automatically, if not answered by the overflow
destination within 60 seconds.
* 1 A call via DIL 1:1, DID.
* 2 A call via DISA, transferred by ATT or
Extension, or a call held by the system as a
treatment of the UCD Time Table.
6. OGM1 and OGM2
To utilize OGM, install Direct Inward System
Access (DISA) card to the system and assign
the usage of DISA card to OGM1 and/or
OGM2 by system programming in advance.
The Operator 1 can record OGM.
Up to four DISA cards can be installed to the
system.
Four OGMs per DISA card can be sent to
outside callers simultaneously.
Refer to Section 3-F-4.00, 4-I-13.00 and
6-J-6.00 "Outgoing Message (OGM)
Recording and Playing Back," for further
information.
(B)
60 seconds later.
will be disconnected
3-D-13
(50195)
7. UCD Timetable
When all extensions in a UCD group are busy,
calls are handled according to the pre-
programmed timetable.
The timetable is assigned to the system by
employing "UCD Time Table-UCD (2/2)" in
system programming.
(1) Number of timetables
Each UCD group (01 to 04) has own timetable
respectively.
(2) Up to 16 steps can be registered per timetable
by selecting a command listed below.
Command list and functions
Command
1T Callers are put in the waiting queue
for 15 seconds.
2T Callers are put in the waiting queue
for 30 seconds.
3T Callers are put in the waiting queue
for 45 seconds.
4T Callers are put in the waiting queue
for 60 seconds.
O1W When OGM1 is in use, wait until
OGM1 becomes available and then
OGM1 is sent to the caller.
O2W When OGM2 is in use, wait until
OGM2 becomes available and then
OGM2 is sent to the caller.
O1S OGM1 is sent to the caller if
available.
When OGM1 is in use, skips to the
next step without sending OGM1.
O2S OGM2 is sent to the caller if
available.
When OGM2 is in use, skips to the
next step without sending OGM2.
H Music-on-Hold is sent to the caller.
TR Transfers a call to the overflow
destination set by "OFDN" of
"Special Attended-UCD(1/2)" in
system programming.
OFF Disconnects the outside call.
RET Returns to the first column.
Note: Any command after "TR" or "OFF" does not
function.
Functions