Installing/Replacing Chest Positioning Straps; Installing; Replacing - Invacare Spree XT Owner's Operator And Maintenance Manual

SECTION 6—BACK/SEAT

Installing/Replacing Chest Positioning Straps

NOTE: For this procedure, refer to FIGURE 6.7.

Installing

1. Position the chest positioning strap to one of the holes on the back cane.
NOTE: The standard recommended position for the chest positioning strap is in the top hole of the
back cane, but may be mounted according to the userʹs needs.
2. Secure the chest positioning strap to the back canes with the new/existing hex screw
and locknut (FIGURE 6.7).
3. Repeat STEPS 1‐2 for opposite side.

Replacing

1. Remove the hex screw that secures the chest positioning strap to the back cane.
2. Discard existing chest positioning strap.
3. Repeat STEPS 1‐2 for opposite side, if necessary.
4. Install the new chest positioning strap. Refer to Installing on page 58.
Back Cane
Locknut
Hex Screw
Chest Positioning Strap
FIGURE 6.7 Installing/Replacing Chest Positioning Straps
58
Spree XT Part No 1118364