Typical Product Parameters - Invacare Spree XT Owner's Operator And Maintenance Manual

TYPICAL PRODUCT PARAMETERS

Overall Width:
Overall Depth:
(W/O Front Riggings)
Overall Height:
Anti-Tippers:
Footrest:
Armrests:
Back:
Back Angle Adjustment:
Rear Axle:
Rear Wheels:
Handrims:
Caster Size:
Seat Width:
Seat Depth:
Back Cane Height:
Wheel Locks:
Tilt-In-Space:
Frame:
Weight Limitation:
NOTE: Measurements based on a 16‐inch wide by 16‐inch deep wheelchair with 12‐inch rear
wheels and 4‐inch casters.
*NOTE: The seat‐to‐floor heights are based on pneumatic tires and pneumatic tires with flat free
inserts. If wheelchair is equipped with urethane tires, subtract 1/4‐inch from the measurements
listed above. All heights are measured with properly inflated new tires. These heights can vary
+1/4‐inch due to tire wear.
Part No 1118364
INVACARE SPREE XT
Open: Seat Width Plus Approximately 9-inches
Closed: Approximately 14-inches
29-1/2-inches
* Seat-to-Floor Height + 21-inches (20-inch back canes
* Seat-to-Floor Height + 25-inches (24-inch back canes
Standard
Swing-Away Footrest - 90° (Standard), 70° or 60°, Lift-off Footrest
(Optional), Elevating Legrests (Optional)
Locking Cantilever Arms - Desk or Full Length
Non-Locking Cantilever Arms
T-Arms - Desk or Full Length, Adjustable Height
Fixed - 20 or 24-inches
86° to 106° (4° increments)
Quick-Release or Permanent
12-inches Pneumatic (Standard)
12-inch Pneumatic w/flat free (Optional)
20, 22 and 24-inch Pneumatic, Urethane, Pneumatic w/flat free, Primo or
KIK® (Optional)
Aluminum Handrims (20, 22 and 24-inch)
3 x 1, 5 x 1, 6 x 1 Urethane (Optional)
4 x 1 Light Up (Standard)
4 x 1, 5 x 1 Semi-Pneumatic (Optional)
6 x 2-inch w/ Precision Sealed Bearings (Optional)
8-inch w/ Precision Sealed Bearings (Optional)
6 x 1-inch w/ Precision Sealed Bearings (Optional)
10-12, 12-14, 14-16, 16-18, 18-20-inches wide
12 to 16-inches (with 2-inch seat rail extension)
12 to 20-inches (with 2-inch seat rail extension)
20 and 24-inches
12, 20, 22, and 24-inch Rear Wheels - Push to Lock, Pull to Lock, Hill
Holder
Dual Cable Trigger Mechanism (Standard) - 45° Tilt
Aluminum
150 lbs.
15
TYPICAL PRODUCT PARAMETERS
Spree XT