Installing/Removing Chest Positioning Strap - Invacare Patriot Owner's Operator And Maintenance Manual

INSTALLING/REMOVING CHEST POSITIONING
STRAP
NOTE: For this procedure, refer to FIGURE 7.5.
1. Remove the two (2) mounting screws and washers securing the back upholstery to the
back cane.
2. Do one (1) of the following:
A. To install the chest positioning strap, proceed to STEP 3.
B. Remove the two (2) existing chest positioning strap halves from the back
upholstery.
3. Engage the two (2) halves of the new chest positioning strap.
4. Align the mounting hole on one (1) end of the new chest positioning strap with the
mounting hole on the back upholstery and back cane.
5. Secure the new chest positioning strap and back upholstery to the back cane with one
(1) mounting screw and washer. Tighten securely.
NOTE: Ensure strap is not twisted and oriented properly when installing.
6. Repeat STEPS 4-5 for opposite side of new chest positioning strap.
\
Chest Positioning
Strap
Back Cane
NOTE: Only hook and loop style chest positioning strap shown. Auto style chest positioning strap
attaches the same way.
FIGURE 7.5 - INSTALLING/REMOVING CHEST POSITIONING STRAP
Part No 1088909
Engage These Ends
Mounting Screw
43
SECTION 7—SEAT/BACK
Chest Positioning
Strap
Mounting Screw
Washers
Patriot™