Installing/Replacing Chest Positioning Straps; Installing; Replacing; Installing And Removing A Seating System - Invacare Compass XE Owner's Operator And Maintenance Manual

Installing/Replacing Chest Positioning Straps

NOTE: For this procedure, refer to FIGURE 7.14.

Installing

1. Position the chest positioning strap to
one of the holes on the back cane.
NOTE: The standard recommended position
for the chest positioning strap is in the top hole
of the back cane, but may be mounted according
to the userʹs needs.
2. Secure the chest positioning strap to the
back canes with the new/existing hex
screw and locknut (FIGURE 7.14).
3. Repeat STEPS 1‐2 for opposite side.

Replacing

1. Remove the hex screw that secures the chest positioning strap to the back cane.
2. Discard existing chest positioning strap.
3. Repeat STEPS 1‐2 for opposite side, if necessary.
4. Install the new chest positioning strap. Refer to Installing/Replacing Chest Positioning
Straps on page 77.

Installing and Removing a Seating System

If a seating system is being used on the wheelchair, refer to the seating system Ownerʹs
Manual for installation and removal.
Part No 1127114
Hex Screw
Chest Positioning Strap
FIGURE 7.14 Installing/Replacing Chest
Positioning Straps
77
SECTION 7—BACK
Back Cane
Locknut
Compass™XE and Allegro®