Removing T-Arms; Adjusting The T-Arms; Adjusting T-Arm Height - Invacare Spree XT Owner's Operator And Maintenance Manual

SECTION 5—ARMS

Removing T-Arms

1. Press the locking lever in and lift the T‐Arm straight up and out of the T‐Arm socket.
NOTE: If the T‐Arm does not slide up and down in the T‐Arm socket as desired, adjust
the T‐Arm socket. Refer to Adjusting T‐Arm Sockets on page 50.
2. Repeat STEP 1 for opposite side of the wheelchair.

Adjusting The T-Arms

Adjusting T-Arm Height

NOTE: For this procedure, refer to
FIGURE 5.9.
1. Unlock the T‐Arm by flipping the
T‐Arm release lever towards the inside
of the wheelchair.
NOTE: If necessary, pull the T‐Arm release
lever out and rotate 180° so it can be flipped
towards the outside of the wheelchair.
2. Slide the T‐Arm to one of:
• Low Height T‐Arms ‐ Nine
positions.
• High Height T‐Arms ‐ Seven
positions.
NOTE: If the inside T‐Arm post does not
slide up and down in the outside T‐Arm
post as desired, perform one of the
following:
• Tighten ‐ Tightening the set screws
on the outside T‐Arm post will
make it more difficult to move the
inside T‐Arm post up and down.
• Loosen ‐ Loosening the set screws on the outside T‐Arm post will make it easier to
move the inside T‐Arm post up and down.
3. Lock the T‐Arm by flipping the T‐Arm release lever towards the front of the
wheelchair.
Spree XT
Set Screws
Outside T- Arm Post
FIGURE 5.9 Adjusting T-Arm Height
48
T-Arm
INSIDE T-Arm Post
T-Arm Release Lever -
LOCKED Position
T-Arm Release Lever -
UNLOCKED Position
Part No 1118364