Installing/Removing Stroller Handles; Installing Stroller Handles; Removing Stroller Handles - Invacare Spree XT Owner's Operator And Maintenance Manual

SECTION 6—BACK/SEAT

Installing/Removing Stroller Handles

NOTE: For this procedure, refer to FIGURE 6.3.

Installing Stroller Handles

1. Remove the plug buttons from both back canes, if necessary.
2. Slide the stroller handle into the back canes.
3. Align the mounting holes of the stroller
handle and the back canes.
4. Press the button on the quick‐release
pin and insert the quick‐release pin
through the back cane and stroller
handle.
5. Release the button on the quick‐release
pin.
6. Pull on the stroller handle to make sure
it is locked securely in place.

Removing Stroller Handles

1. Push in the buttons of the quick‐release pins.
2. Pull out the quick‐release pins that secure the stroller handle to the back canes.
3. Remove the stroller handle from the wheelchair.
4. Install the NEW stroller handle if desired. Refer to Installing Stroller Handles on
page 54.
Spree XT
Button
Quick-Release Pin
FIGURE 6.3 Installing/Removing Stroller
54
Stroller Handle
Mounting
Holes
Back Cane
Handles
Part No 1118364