Installing/Replacing Chest Positioning Straps; Installing; Replacing - Invacare Compass SPT PH904A Owner's Operator And Maintenance Manual

SECTION 6—BACK/SEAT

Installing/Replacing Chest Positioning Straps

NOTE: For this procedure, refer to FIGURE 6.6.

Installing

1. Position the chest positioning strap to one of the holes on the back cane.
NOTE: The standard recommended position for the chest positioning strap is in the top hole of the
back cane, but may be mounted according to the userʹs needs.
2. Secure the chest positioning strap to the back canes with the new/existing hex screw
and locknut (FIGURE 6.6).
3. Repeat STEPS 1-2 for opposite side.

Replacing

1. Remove the hex screw that secures the chest positioning strap to the back cane.
2. Discard existing chest positioning strap.
3. Repeat STEPS 1-2 for opposite side, if necessary.
4. Install the new chest positioning strap. Refer to Installing/Replacing Chest Positioning
Straps on page 52.
FIGURE 6.6 Installing/Replacing Chest Positioning Straps
Compass™SPT™
Hex Screw
Chest Positioning Strap
52
Back Cane
Locknut
Part No 1122134