Vehicle-Anchored Belts; Seating System - Invacare Spree XT Owner's Operator And Maintenance Manual

SECTION 11—TRANSPORT READY OPTION

Vehicle-Anchored Belts

NOTE: For this procedure, refer to FIGURE 11.2.
This wheelchair has an overall rating of "A" with regard to accommodating the use and
fit of vehicle‐anchored belts. This rating is scored as follows:
The test for Lateral Stability Displacement for Point (P) is shown in FIGURE 11.2. The
average test result for point (P) is 0.8125‐inches (21.5 mm).
Test
Platform

Seating System

This wheelchair has been tested for seating in a motor vehicle with the factory
installed seating system ONLY.
When feasible, wheelchair occupants should transfer into the vehicle seat and use
the OEM (Original Equipment Manufacturer) vehicle-installed restraint system.
NOTE: For this procedure, refer to FIGURE 11.3.
The factory installed seating system has a
front mounting bracket on the seat which
must be secured to the wheelchair frame.
1. Securely tighten the mounting screw(s)
to secure the front of the seat to the
wheelchair frame.
2. Refer to the instructions which came
with the seating system for additional
information.
Spree XT
RATING
A
B
C
D
Rear View
Point (P)
°
45
FIGURE 11.2 Vehicle-Anchored Belts
WARNING
DESCRIPTION
Excellent
Good
Fair
Poor
NOTE: Rear view of
wheelchair and human
surrogate secured on test
platform and tilted to 45
degrees.
Front Mounting
Bracket
Mounting
Screw
FIGURE 11.3 Seating System
74
Seat
Part No 1118364