Adjusting Non-Locking Cantilever Arm Height; Adjusting Non-Locking Cantilever Arm Angle - Invacare Spree XT Owner's Operator And Maintenance Manual

SECTION 5—ARMS

Adjusting Non-Locking Cantilever Arm Height

NOTE: For this procedure, refer to FIGURE 5.5.
1. Remove the locknut and washer from the lower hex bolt securing the cantilever arm
to the back cane.
2. Slide the cantilever arm assembly out of the back cane.
3. Reposition the cantilever arm assembly to the desired mounting hole.
4. Secure the cantilever arm to the wheelchair with a washer and locknut.

Adjusting Non-Locking Cantilever Arm Angle

NOTE: For this procedure, refer to FIGURE 5.6.
1. Loosen the mounting screw securing the cam to the cantilever arm.
2. Rotate the cam until the desired angle is achieved (Detail ʺBʺ).
3. Tighten the mounting screw securing the cam to the cantilever arm.
Side View of Cam
Back
Cane
0° Arm Angle
Back
Cane
Cam
FIGURE 5.6 Adjusting Non-Locking Cantilever Arm Angle
Spree XT
Cam
Cantilever
Arm
DETAIL "B" - CAM POSITIONS
4° Arm Angle 8° Arm Angle
Back
Cane
Cam
NOTE: All arm angles are relative to the back cane.
12° Arm Angle
Back
Cane
Cam
46
Back Cane
Cantilever Arm
16° Arm Angle
Back
Back
Cane
Cane
Cam Cam
Part No 1118364