Adjusting Locking Cantilever Arm Angle - Invacare Spree XT Owner's Operator And Maintenance Manual

SECTION 5—ARMS

Adjusting Locking Cantilever Arm Angle

NOTE: For this procedure, refer to FIGURE 5.3.
NOTE: This adjustment is recommended if the back angle has been changed to keep arm parallel
to the ground/floor.
1. Flip the cantilever arm up and out of the way.
2. Remove the locknut that secures the locking pin to the arm adjustment plate.
3. Determine the mounting hole in the arm adjustment plate that will be used to
correspond to the back angle (FIGURE 5.3).
4. Securely tighten the locking pin and washer to the adjustment plate with a locknut.
5. Repeat STEPS 1‐4 for the opposite side, if necessary.
Adjustment Plate
Locknut
Locking Pin
Washer
DETAIL "A" - CORRESPONDING ARM ADJUSTMENT TO BACK ANGLE
94°
86° 90°
Back Angle Bracket
Back Angle Bracket
Back Angle Bracket
Arm
Arm
Arm
Adjustment
Adjustment
Adjustment
Plate
Plate
Plate
98° 102° 106°
Back Angle Bracket
Back Angle Bracket
Back Angle Bracket
Arm
Arm Adjustment
Adjustment
Arm Adjustment
Plate
Plate
Plate
NOTE: This adjustment will ensure the arm is parallel to the seat.
FIGURE 5.3 Adjusting Locking Cantilever Arm Angle
44
Spree XT Part No 1118364