Removing Stroller Handles; Adjusting The Adjustable Angle Stroller Handles; Installing/Replacing Seat Positioning Straps; Installing - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

SECTION 8—BACK/SEAT

Removing Stroller Handles

1. Remove the locknuts that secure the stroller handle to the back cane.
2. Pull out the bolts that secure the stroller handle to the back canes.
3. Remove the stroller handle from the wheelchair.
4. Install the new stroller handle if desired. Refer to Installing Stroller Handles on
page 57.

Adjusting the Adjustable Angle Stroller Handles

NOTE: For this procedure, refer to FIGURE 8.4.
1. Press and hold in both buttons on the outside of the hinge arm of the stroller handle.
2. Adjust stroller handle to desired angle.
3. Release the buttons.
4. Push down on stroller handle to ensure hinge arms hold the desired position of the
stroller handle.
NOTE: There will be an audible click.
NOTE: If hinge arms DO NOT hold the position, contact Invacare technical support.
FIGURE 8.4 Adjusting the Adjustable Angle Stroller Handles

Installing/Replacing Seat Positioning Straps

NOTE: For this procedure, refer to FIGURE 8.5 on page 59.

Installing

1. Remove the hex screw and locknut that secures the back cane to the back plate.
2. Position the seat positioning strap against the back plate.
3. Install the hex screw through the seat positioning strap, coved spacers and back cane.
4. Securely tighten the seat positioning strap to the wheelchair with the locknut.
5. Repeat STEPS 1-4 for opposite side.
® ™
Solara /Spree GT
Adjustable Angle
Stroller Handle
Button
58
Hinge Arm
Part No 1125027